Owning

The running costs that add up: tires, wheels, winter sets and the fuel grade. Every figure carries its source and date.

Four tools, each on its own page

Owning, explained

Which owning tool do you need?

Tire Treadlife compares tires by cost per mile and works out what a prorated treadwear warranty pays. Wheel Fitment checks a new wheel against the one on the car. Winter Tires prices all-season, all-weather and winter setups per season, and Regular vs Premium tells you whether the fuel grade is worth paying for.

Every default names its source and as-of date under How this is calculated.

Frequently asked questions

How does AutoSmith estimate tire treadlife?

The Tire Treadlife calculator uses the UTQG treadwear grade times 250 miles as a conservative real-world starting point. Aggressive driving, under-inflation, misalignment, and hot climates shorten treadlife; gentle highway driving can extend it. You can override the estimate with your own expected mileage.

What does a treadwear warranty actually pay?

A treadwear warranty is almost always prorated. The manufacturer calculates how many miles of coverage remain and pays a percentage of the original tire price based on that fraction. Some plans also compare the remaining tread depth. The calculator shows both the mileage-based credit and the depth-based credit and highlights the lower, more conservative amount.

How do I convert wheel offset to backspacing?

Add 1 inch to the stamped wheel width to approximate the overall width including both flanges, halve it, then add the offset converted to inches (offset in mm divided by 25.4). An 8-inch wheel at ET45 has about 4.5 + 1.77 = 6.27 inches of backspacing.

Will a wider wheel with lower offset poke past my fenders?

The outer lip moves out by half the width increase plus the offset decrease. Going from 8 inches ET45 to 9 inches ET35 moves the outer lip 12.7 + 10 = 22.7 mm outward. Measure your current gap from the wheel lip to the fender lip and subtract that change to see whether the new wheel pokes, sits flush, or tucks.

Can I use a wheel with a close but different bolt pattern?

No. Patterns such as 5x114.3 and 5x115 look interchangeable, but the studs do not line up with the holes, so the lug nuts cannot seat and clamp evenly. The wheel must be drilled for your exact pattern. Inch and metric names for the same pattern, such as 5x4.5 and 5x114.3, describe the same pattern.

Do I need hub-centric rings?

If the wheel center bore is larger than your hub, the wheel is lug-centric and is centered only by the lug nuts. A hub-centric ring fills the gap: its outside diameter matches the wheel bore and its inside diameter matches the hub. If the wheel bore is smaller than the hub, the wheel will not seat at all.

Are winter tires worth the cost?

Where roads stay below 45 degrees F for weeks, usually yes. Winter tires stop about 35% shorter than all-seasons on packed snow (University of Michigan), and while they are on the car your other tires are not wearing out, so the real extra cost per season is far below the sticker price. Mounting each swap or buying a second set of wheels decides the rest.

Do I need premium gas if my car recommends it?

No. If the owner's manual says premium is recommended rather than required, regular is safe and the choice is yours; the engine adjusts its timing and may lose a little power and mileage. If premium is required, use it. In cars designed for regular, fueleconomy.gov says higher octane gives little to no benefit in normal driving.

How AutoSmith works

What is new